Product description
Getex is a high quality, one pack general purpose adhesive. It consists of a blend of synthetic rubber (neoprene) and resin solution particularly for bonding a wide variety of materials.
Special features
GTC Getex due to its special formulation gives a high bonding strength in a short time allowing immediate handling of bonded materials. However it’s maximum strength is attained after approximately 48 hours at normal room temperature.
Where to use
Getex is used almost everywhere. In homes, offices, workshops and constructions sites. Getex is typical for use in carpentry and decorative works for bonding laminated plastics for working tops and many rigid plastics such as PVC & ABS to wood, metal and all types of boards. Getex is also used for fixing carpets, footwear and leather industry, automotive, caravan furniture, paper and art works, preventing ground water in constructions and buildings, and many other industries. It is not suitable for use on expanded polystyrene or any other materials which are subjected to attack by organic solvents.
Product data
Appearance : Off White to amber. Consistency : Getex is supplied at 15 to 20 poise viscosity which is suitable for application by brush or serrated spreader. Odour : Odour of organic solvents, particularly of Ketones and esters. Flash Point : Highly flammable material. Bond Strength : Shear strength 25mmx25mm. Bonded area. Laminated plastic / plywood 165 KGF. Laminated plastic / mild steel 185 KGF. Coverage : 5.5 SQ MT/LTR. Approx. Standards : - All phases of the installation should comply with the following standards and any subsequent amendments. - British standard code of practice CP 102:1973 protection of building against water from the ground. - British standard code of practice CP203:part 2:1972–sheet and tile flooring. - Code of practice BS5325 : 1976 – installation of textile floor coverings. - CFA flooring compendium for architects specifies.
Surface preparation
All surfaces must be clean, dry and free from Loose particles and grease. It is recommended that smooth or polished surfaces should be roughed with fine abrasive paper followed by dusting off. Application of Adhesive : Apply a thin even film of adhesive to both surfaces by brush or serrated spreader. Assembly : When touch dry, the coated surfaces can be positioned and pressed together. It is important that the two surfaces are lined up accurately before pressing together because the adhesive provides an instant strong bond on contact.
Important restrictions
Application should be carried out in well ventilated conditions and great care should be taken that there are no make flames, pilot lights or other sources of ignition near by.
Storage
When stored in original unopened container in a cool dry place has a shelf life at least six months. The storage conditions should be suitable for highly flammable materials.
Application conditions
At a temperature ranging 5°C (41°F) to 40°C (104 °F) . Relative humidity is below 75%.
Storage and handling
Product must be stored as per local regulations and should be kept in dry well ventilated location far from heat and direct sunlight. Can should be tightly closed after use. Mix well before use. Storage temperature range between 5°C (41°F) to 40°C (104 °F).
Safety precautions
The following notes should be considered when using/applying material:- (a) Take precautions to prevent material entering the eyes (goggles should be worn, irrigate the eyes with water when become contaminated and obtain medical care at one). (b) Take precautions to avoid skin contact (gloves should be worn, barrier cream should be used). (c) Ensure that repeated contact of paint with skin is avoided. (d) Provide adequate ventilation. (Face masks must be worn). (e) Keep away from sparks and open flames (for solvent-based materials).
Pack sizes
• Gallon (3 kg) .