Product description
GTC two component epoxy for bonding pavement markers is a solvent free system based on an epoxy resin base and the ANCAMINE Piperazin as a hardener. The system has a high reactivity and good colour stability.
Special features
• a8 Road marker adhesive is specially formulated to fix ceramic studs and cat eyes. It builds a very storage bonding between the studs and the surface in few minutes. Road markers adhesive resists water and acids.
Where to use
Road Marker adhesive is used specially for ceramic studs and cat eyes to be fixed on the roads.
Product data
Gel Time : Affected highly by ambient temp. but usually 10-30 minutes. Tensile Strength : Tested according to ASTM 2095-72 has a minimum value of 70 KG/CM2. Shord hardness : Tested according to ASTM 2240-81 has a value of 30 @ 49 C. Deformation Temp. : Tested according to ASTM 648-72 has a minimum of 49 C. Solid Content : 100 % solid. Curing Time : 24 hrs. fully cured.
Application details
• a8 Surface preparation :- The surface of the road and the marker should be clean, and free from oil, grease, dust and loose gravel. • a8 Application of Adhesive :- Warm the stud before, then apply the required mixed quantity of adhesive to the back of the stud. Press the stud to the surface. • a8 Assembly :- When touch dry, the adhesive coated surface can be positioned and pressed together.
Application conditions
At a temperature ranging 5°C (41°F) to 40°C (104 °F). Relative humidity is below 75%.
Storage and handling
Product must be stored as per local regulations and should be kept in dry well ventilated location far from heat and direct sunlight. Can should be tightly closed after use. Mix well before use. Storage temperature range between 5°C (41°F) to 40°C (104 °F).
Standards and approvals
Supportive information is available upon request. Please consult with GTC Technical Service Dept.
Safety precautions
The following notes should be considered when using/applying material:- (a) Take precautions to prevent material entering the eyes (goggles should be worn, irrigate the eyes with water when become contaminated and obtain medical care at one). (b) Take precautions to avoid skin contact (gloves should be worn, barrier cream should be used). (c) Ensure that repeated contact of paint with skin is avoided. (d) Provide adequate ventilation. (Face masks must be worn). (e) Keep away from sparks and open flames (for solvent-based materials).
Pack sizes
• a 20 kg Drum (Part A). • a 20 kg Drum (Part B).